Cognitive Solutions Cxi Betriebsanweisung PDF herunterladen (Seite 282)

TROUBLESHOOTING

30. Cause: If programming a high speed Barcode Blaster, Blazer

Emulation Mode may be enabled.

Cure: Disable Blazer Emulation Mode unless your application

strictly requires it.

Printer does not index properly.

31. Cause: The printer received a NOINDEX command. NOINDEX

remains in effect until the printer is turned off or receives an

INDEX command.

Cure: Send the printer an INDEX command. Confirm that your label

format does not contain an unwanted NOINDEX.

32. Cause: For printers that can use both black bar and gap

indexing, the printer may be set for the wrong index type.

Cure: Change print media or set the printer up for the proper

indexing mode. See the sample printer configuration files for more

information.

33. Cause: The printer index detector needs calibration.

Cure: If you are using a Code Courier printer, calibrate the index

detector according to the instructions in your User's Guide. If using a

Barcode Blaster or Blaster Advantage, refer to the VARIABLE

INDEX SETTING command for index calibration information.

34. Cause: Butt-cut label stock is loaded. The printer may be

indexing properly, but with butt-cut stock the labels may not

index to the label perforation, depending on the black bar

position.

Cure: None. This is a normal condition. Use gap stock if this

behavior is unacceptable.

NOTE: The Del Sol’s lower index sensor must be in the center position for Gap

indexing.

Printer skips labels during printing.

35. Cause: Max Y value in Header line is too large.

Cure: Recalculate Max Y value.

1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 291 292

Keine Kommentare

Cognitive Solutions Cxi Betriebsanweisung Seite 282